How Concrete Leveling Is Done

Contrary to what most people may think, concrete is actually easy to level. It is always handy to have some basic knowledge of how it is done but it’s never a good idea to attempt the other man’s work if you don’t have to. Many reasons exist why you should hire a professional concrete contractor, like Foundation Repair Colorado Springs. It’s not that you won’t be able to do it yourself, it’s just that it’s just not something that is done every day by most people without the proper tools and experience.

Preparation

The first step is to have the ground prepared especially for the amount of dirt and other factors that could hinder the job such as moisture, oil, or cracks. Whatever the cases may be, your concrete contractor will probably show you how to proceed to remove these problems. Some people think that the preparation should only take a day but in reality, filling the holes with concrete usually takes no more than between three to four hours depending on how big the job is. Your contractor is skilled at this field and knowing what to expect is important as well.

The first stage of the concrete leveling process is to pour the floor with virgin concrete. This mix should be free from cracks so your contractor will probably sprinkle a little water to ensure that the concrete sticks. Also, the mix should be 8-10 pounds per square foot.

Now that the clean-up is done, you can be left with a perfectly leveled concrete floor for you to work with. Your contractor may want to check the level using a level or another instrument to verify that the concrete has been leveled appropriately.

Laying the Concrete

Before you even start grinding and mixing your floor, your contractor will need to lay the first layer of concrete by pouring a pre-stabilized layer to prevent any additional mix of the concrete from sinking in. You can let the first layer of concrete settle for 30 minutes and then proceed with the next layer. Then, you can follow up by pouring a layer of concrete that is quite thick.

Wet Sand

In case you’ve never leveled the concrete before and there’s a need for you to go back to the prior step where you’ll have to mix some sand to the concrete to enhance the texture, then the wet sand will be used to smooth the surface again. The wet sand can be mixed up into a thick paste to make it easier to spread all over the concrete. Say, the thick layer is 1.5 to 2 meters in thickness.

Shaping Will Help

If your concrete floor has large curves, there’s a threat that it will surely look like it’s not flat. It’s best to use a wooden straightedge when attempting to cure the concrete following this step. The wooden molding will make it easier for you to straighten the concrete by achieving an angular shape.

Dressing Up

After of getting rid of excess dirt with the use of a vacuum, your next step will be to apply a finish of your preference. But if the concrete floor shows some unwanted cracks or damage, then applying some concrete overlay will do the trick. This is considered a repair and not a replacement. This is especially true if the cracks inspected by your contractor were deeper than 1/8 inch. Corrosion and water leaks really destroy the look of the floor so it’s better to get it repaired at the earliest.

Curing Process

Once the finish is applied, the next step will be to cure the concrete with a metal gas form. Typically, you will wait up to three days for the concrete to actually cure.

Once the concrete has set, it’s time to enjoy the fruits of your labor. Now, there’s no need for you to start worrying about how the floor looks since you have a beautiful, reinforced, and durable one right under your nose.